Nissan Note Owners Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
74 Posts
Discussion Starter #1
Hello,

Don't unusualy deal with exhausts but started with this one and learning a lot about exhausts very quickly and somethings might not be very conservative with this one.

Anyway here goes

My usual go to method of removing rusty nuts and bolts it to apply heat and then give them a little shake with and impact and this method worked on one of the two as can be seen in the attached picture.

Any tips and suggestions of removing the remaining stud before I resort to drilling it out would be appreciated.
1154


Thankyou for your help in advance John.

Mods please feel free to move this thread if it's in the wrong location
 

·
Registered
Joined
·
781 Posts
By the look of what you hold in the picture i would say you have little option but to drill it out.
 

·
Registered
Joined
·
74 Posts
Discussion Starter #3
By the look of what you hold in the picture i would say you have little option but to drill it out.
Thankyou that's excasty what I did. Not very familiar with exhaust construction, they somehow spot weld those studs in. One came out with a few blows of a hammer and the other drilled out.
 
1 - 4 of 4 Posts
Top